2910530 Phoenix Contact Control Relays

Product Details

• Nominal input voltage UN
  24 V DC
• Minimum switching voltage
  12 V (10 mA)
• Limiting continuous current
  10 A
• Operating mode
  100% operating factor
• Assembly instructions
  In rows with zero spacing
• Rated insulation voltage
  250 V AC
• UL, USA/Canada
  cUL 508
• ECLASS 10.0.1
  27371601
• ECLASS 7.0
  27371601
• UNSPSC 6.01
  30211916
• ETIM 4.0
  EC001437
• UNSPSC 19.0
  39122334
• UNSPSC 21.0
  39122334
• Degree of protection
  RT II (Relay)
• Typical release time
  10 ms
• Min. switching current
  10 mA (at 12 V)
• Flammability rating according to UL 94
  V0 (Housing)
• Connection name
  Contact side
• Conductor cross section AWG
  26 ... 14
• Pollution degree
  2
Identification
ISA-S71.04. G3 Harsh Group
ECLASS 6.0
27371600
ETIM 2.0
EC001437
ETIM 7.0
EC001437
UNSPSC 18.0
39122334
Overvoltage category
III
China RoHS
Environmentally Friendly Use Period = 50 years
ECLASS 9.0
27371601
UNSPSC 11
39121515
UNSPSC 20.0
39122334
Typical response time
10 ms
Type of switch contact
Single contact
Switching capacity
2 A (24 V, DC13)
Maximum inrush current
24 A (20 ms)
Mounting position
any
Conductor cross section solid
0.14 mm² ... 2.5 mm²
Rated surge voltage
6 kV
REACh SVHC
Lead 7439-92-1
ECLASS 5.1
27371600
ETIM 3.0
EC001437
UNSPSC 12.01
39121515
Typical input current at UN
18 mA
Test voltage
4 kVrms (50 Hz, 1 min., winding/contact)
Interrupting rating (ohmic load) max.
264 W (24 V DC)
Insulation
Safe isolation, reinforced insulation
UL, USA
UL 508
ECLASS 5.0
27371600
ETIM 6.0
EC001437
UNSPSC 13.2
39122334
Utilization restriction
EMC: class A product, see manufacturer's declaration in the download area
Ambient temperature (operation)
-20 °C ... 60 °C
Maximum switching voltage
250 V AC/DC (The separating plate PLC-ATP should be installed for voltages larger than 250 V (L1, L2, L3) between identical terminal blocks in adjacent modules. Potential bridging is then carried out with FBST 8-PLC... or ...FBST 500...)
Connection method
Push-in connection
Standards/regulations
EN 50178
Designation
Corrosive gas test
Width
14 mm
Ambient temperature (storage/transport)
-20 °C ... 85 °C
Contact material
AgNi
Conductor cross section flexible
0.14 mm² ... 2.5 mm²
Depth
104 mm
Coil voltage
24 V DC
Operating voltage display
Yellow LED
ECLASS 11.0
27371601
Height
80 mm
Contact type
1 changeover contact
Mechanical service life
5x 106 cycles
Maximum altitude
≤ 2000 m
Protective circuit
Reverse polarity protection Polarity protection diode
Stripping length
8 mm
UNSPSC 7.0901
39121515