2909884 Phoenix Contact Control Relays

Product Details

• ECLASS 6.0
  27371600
• Utilization restriction
  EMC: class A product, see manufacturer's declaration in the download area
• Depth
  75 mm
• Degree of protection
  IP20 (Relay base)
• Coil voltage
  24 V DC
• Contact type
  1 N/O contact
• Minimum switching voltage
  12 V AC/DC (at 100 mA)
• Switching capacity
  2 A (at 24 V, DC13)
• ETIM 6.0
  EC001437
• Height
  93 mm
• Nominal input voltage UN
  24 V DC
• Power dissipation for nominal condition
  0.43 W
• Contact material
  AgSnO
• Switching capacity min.
  1200 mW
• Mechanical service life
  3x 107 cycles
• Connection method
  Push-in connection
• Designation
  Corrosive gas test
• Insulation
  Safe isolation, reinforced insulation
• Identification
  ISA-S71.04. G3 Harsh Group
• Type of note
  Notes on operation
Ambient temperature (operation)
-40 °C ... 70 °C
Input voltage range in reference to UN
see diagram
Typical response time
8 ms
Maximum switching voltage
250 V AC/DC (The separating plate PLC-ATP should be installed for voltages larger than 250 V (L1, L2, L3) between identical terminal blocks in adjacent modules. Potential bridging is then carried out with FBST 8-PLC... or ...FBST 500...)
Interrupting rating (ohmic load) max.
264 W (at 24 V DC, observe contact derating)
Test voltage
4 kV AC (50 Hz, 1 min., winding/contact)
Mounting position
any
Conductor cross section AWG
26 ... 16 (solid)
Rated insulation voltage
250 V AC
Overvoltage category
III
ECLASS 11.0
27371601
Note
FBS 2-6... plug-in bridge for the input side (A2) and FBS-2-8... plug-in bridge for the output side (11/21)
Ambient temperature (storage/transport)
-40 °C ... 85 °C
Typical release time
10 ms
Protective circuit
Free-wheeling diode Damping diode
Type of switch contact
Single contact
Min. switching current
100 mA (at 12 V DC)
Operating mode
100% operating factor
Assembly instructions
In rows with zero spacing
Conductor cross section flexible
0.14 mm² ... 1.5 mm²
Standards/regulations
EN 50178
ECLASS 10.0.1
27371601
ECLASS 5.0
27371600
ECLASS 7.0
27371601
ETIM 4.0
EC001437
Width
16 mm
Maximum altitude
≤ 2000 m
Typical input current at UN
18 mA
Operating voltage display
Yellow LED
Maximum inrush current
80 A (for 20 ms)
Limiting continuous current
6 A
Connection name
Contact side
Conductor cross section solid
0.14 mm² ... 1.5 mm²
Stripping length
8 mm
Rated surge voltage
6 kV
Pollution degree
2
China RoHS
Environmentally Friendly Use Period = 50 years
ECLASS 5.1
27371600
ETIM 3.0
EC001437
ETIM 7.0
EC001437
ECLASS 9.0
27371601
ETIM 2.0
EC001437