2907066 Phoenix Contact UPS (DC)

Product Details

• Weight
  0.5 kg
• Depth
  125 mm
• Installation height
  ≤ 4000 m
• Reverse polarity protection
  yes
• No-load proof
  yes
• Energy storage device connection in series
  no
• Installation distance right/left (active)
  5 mm / 5 mm (POut ≥50% )
• Degree of protection
  IP20
• Ambient temperature (start-up type tested)
  -40 °C
• Max. permissible relative humidity (operation)
  ≤ 95 % (at 25 °C, non-condensing)
• Selective Fuse Breaking (ISFB)
  60 A (15 ms)
• Charging time
  160 min. (7.2 Ah)
• Charge characteristic curve
  IU0U
• Inrush current
  ≤ 7 A (≤ 4 ms)
• Height with alternative assembly
  130 mm
• Installation distance top/bottom (active)
  50 mm / 50 mm (POut ≥50% )
• Climatic class
  3K3 (EN 60721)
• Switch-over time
  0 ms
• Output voltage range
  19 V DC ... 28 V DC (UOUT = UBAT - 0.4 V DC)
• Static Boost (IStat.Boost)
  12.5 A
End-of-charge voltage (temperature-compensated)
25 V DC ... 32 V DC
Temperature compensation (configurable)
42 mV/K
Width with alternative assembly
123 mm
Installation distance top/bottom (active, passive)
40 mm / 20 mm (POut ≤50 %)
Inflammability class in acc. with UL 94 (housing / terminal blocks)
V0
Ambient temperature (storage/transport)
-40 °C ... 85 °C
Input voltage range
18 V DC ... 30 V DC
Internal input fuse
no
Voltage drop, input/output
0.4 V DC
Energy storage device connection in parallel
Yes, 5 (observe line protection)
Battery technology
VRLA, VRLA-WTR, LI-ION
Buffer time
25 min. (7.2 Ah)
Temperature sensor
yes
Environmental protection directive
RoHS Directive 2011/65/EU
Conductor cross section flexible min.
0.2 mm²
Conductor cross section AWG min.
30
Standard designation
Safety extra-low voltage
Standards/regulations
IEC 61010-1 (SELV)
Fast transients (burst)
EN 61000-4-4
Input
1 kV (Test Level 3 - symmetrical)
Voltage
10 V (Test Level 3)
Frequency
0 Hz
ECLASS 10.0.1
27040705
UNSPSC 18.0
39121011
Width
35 mm
Installation distance right/left (active, passive)
0 mm / 0 mm (POut ≤50 %)
Installation distance top/bottom (passive)
40 mm / 20 mm (POut ≥50% )
Input voltage
24 V DC
Switch-on time
max. 3 s
UPS connection in parallel
no
Efficiency
typ. 98 %
Dynamic Boost (IDyn.Boost)
20 A (5 s)
Nominal capacity (without additional charger)
1.2 Ah ... 80 Ah
Life expectancy (electrolytic capacitors)
137895 h
Conductor cross section AWG max.
12
Single conductor/terminal point, stranded, with ferrule, max.
2.5 mm²
Electromagnetic compatibility
Conformance with EMC Directive 2014/30/EU
Electrostatic discharge
EN 61000-4-2
Electromagnetic HF field
EN 61000-4-3
Conducted interference
EN 61000-4-6
Surge voltage load (surge)
EN 61000-4-5
ECLASS 5.1
27242213
Criterion B
Temporary impairment to operational behavior that is corrected by the device itself.
ECLASS 9.0
27040705
Height
130 mm
Depth with alternative assembly
37 mm
Installation distance right/left (passive)
0 mm / 0 mm (POut ≥50% )
Ambient temperature (operation)
-25 °C ... 70 °C (> 60 °C Derating: 2.5 %/K)
Degree of pollution
2
Electric strength, max.
35 V DC (Protected against polarity reversal)
Fixed backup threshold
22 V DC
Short-circuit-proof
yes
UPS connection in series
no
Max. capacity
80 Ah
Charging current (configurable)
max. 3 A
IQ-Technology
yes
Conductor cross section solid min.
0.2 mm²
Single conductor/terminal point, stranded, with ferrule, min.
0.2 mm²
Tightening torque, min
0.5 Nm
EMC requirements for noise emission
EN 61000-6-3
Identification
IEC 61010-1
Discharge in air
15 kV (Test Level 4)
Signal
1 kV (Test Level 2 - asymmetrical)
I/O/S
asymmetrical
Criterion A
Normal operating behavior within the specified limits.
ETIM 7.0
EC000382
UNSPSC 20.0
39121011
MTBF (IEC 61709, SN 29500)
> 2065000 h (25 °C)
Conductor cross section solid max.
2.5 mm²
EMC requirements for noise immunity
EN 61000-6-1
Designation
CB scheme
Contact discharge
8 kV (Test Level 4)
Frequency range
50 Hz ... 60 Hz
Test field strength
300 A/m
Additional text
DC, 60 s
ECLASS 11.0
27040705
ETIM 6.0
EC000382
UNSPSC 21.0
39121011
Connection method
Screw connection
Conductor cross section flexible max.
2.5 mm²
Tightening torque max
0.6 Nm
Stripping length
6.5 mm
Low Voltage Directive
Conformance with Low Voltage Directive 2014/35/EC
Comments
Criterion A
Output
1 kV (Test Level 3 - symmetrical)
Power frequency magnetic field
EN 61000-4-8
REACh SVHC
Lead 7439-92-1
UNSPSC 19.0
39121011
UNSPSC 13.2
39121004