1136244 Phoenix Contact Control Relays

Product Details

• Contact type
  2 changeover contacts
• Min. switching current
  10 mA (5 V)
• Mechanical service life
  approx. 3x 107 cycles
• Conductor cross section solid
  0.14 mm² ... 2.5 mm²
• Rated insulation voltage
  250 V AC
• Overvoltage category
  III
• ECLASS 11.0
  27371601
• Note
  The PLC-ATP separating plate is required at the start and end of every PLC terminal strip.
• Ambient temperature (operation)
  -40 °C ... 55 °C
• Maximum altitude
  ≤ 2000 m
• Mains frequency
  50/60 Hz
• Typical release voltage
  50 V AC
• Status display
  Yellow LED
• Protective circuit
  RC element
• Maximum switching voltage
  250 V AC/DC
• Limiting continuous current
  6 A
• Test voltage
  4 kVrms (50 Hz, 1 min., winding/contact)
• Conductor cross section AWG
  26 ... 14
• Rated surge voltage
  4 kV (Safe isolation, reinforced insulation, and 6 kV between input circuit and output contact current paths)
• REACh SVHC
  Lead 7439-92-1
Type of note
Assembly instruction:
Height
80 mm
Ambient temperature (storage/transport)
-40 °C ... 85 °C
Nominal input voltage UN
120 V AC
Typical response time
7 ms
Coil voltage
110 V DC
Contact material
AgNi
Minimum switching voltage
5 V (10 mA)
Switching capacity min.
0.12 W
Connection method
Push-in connection
Conductor cross section flexible
0.2 mm² ... 2.5 mm²
Insulation
Basic insulation
ECLASS 10.0.1
27371601
ECLASS 9.0
27371601
Utilization restriction
EMC: class A product, see manufacturer's declaration in the download area
Width
14 mm
Depth
94 mm
Degree of protection
IP20 (Relay base)
Typical input current at UN
6 mA (50 Hz)
Typical release time
10 ms
Type of switch contact
Single contact
Maximum inrush current
15 A (300 ms, N/O contact)
Operating mode
100% operating factor
Mounting position
any
Conductor cross section flexible (2 conductors with same cross section)
0.5 mm² ... 1 mm²
Designation
Corrosive gas test
Pollution degree
2
Interrupting rating (ohmic load) max.
144 W (24 V DC)
Assembly instructions
In rows with zero spacing
Stripping length
8 mm
Standards/regulations
DIN EN 50178
Identification
ISA-S71.04. G3 Harsh Group
China RoHS
Environmentally Friendly Use Period = 50 years