1119897 Phoenix Contact Control Relays

Product Details

• Depth
  94 mm
• Utilization restriction
  EMC: class A product, see manufacturer's declaration in the download area
• Height
  80 mm
• Degree of protection
  RT III (Relay)
• Typical release time
  8 ms
• Type of switch contact
  Single contact
• Maximum inrush current
  10 A (4 s)
• Operating mode
  100% operating factor
• Screw thread
  M3
• Designation
  Corrosive gas test
• REACh SVHC
  Lead 7439-92-1
• Note
  The system installer must ensure the touch protection of the product (at voltages > 25 V AC/60 V DC). The product is a built-in device without protection against direct contact.
• Maximum altitude
  ≤ 2000 m
• Typical input current at UN
  38 mA
• Contact type
  1 changeover contact
• Minimum switching voltage
  5 V (at 100 mA)
• Test voltage
  4 kVrms (50 Hz, 1 min., winding/contact)
• Assembly instructions
  In rows with zero spacing
• Conductor cross section AWG
  26 ... 14
• Rated surge voltage
  6 kV
Overvoltage category
III
China RoHS
Environmentally Friendly Use Period = 50 years
Type of note
Notes on operation
Ambient temperature (operation)
-40 °C ... 60 °C
Typical response time
5 ms
Maximum switching voltage
250 V AC/DC (The separating plate PLC-ATP should be installed for voltages larger than 250 V (L1, L2, L3) between identical terminal blocks in adjacent modules. Potential bridging is then carried out with FBST 8-PLC... or ...FBST 500...)
Interrupting rating (ohmic load) max.
140 W (at 24 V DC)
Connection method
Screw connection
Stripping length
8 mm
Identification
ISA-S71.04. G3 Harsh Group
ECLASS 9.0
27371601
Width
6.2 mm
Ambient temperature (storage/transport)
-40 °C ... 85 °C
Protective circuit
Reverse polarity protection Polarity protection diode
Operating voltage display
Yellow LED
Min. switching current
10 mA (at 12 V)
Flammability rating according to UL 94
V0 (Housing)
Mechanical service life
2x 107 cycles
Connection name
Contact side
Conductor cross section flexible
0.14 mm² ... 2.5 mm²
Standards/regulations
EN 50178
Insulation
Safe isolation, reinforced insulation
ECLASS 10.0.1
27371601
ECLASS 11.0
27371601
Nominal input voltage UN
5 V DC
Coil voltage
4.5 V DC
Contact material
AgSnO
Limiting continuous current
6 A
Switching capacity
2 A (at 24 V, DC13)
Mounting position
any
Conductor cross section solid
0.14 mm² ... 2.5 mm²
Rated insulation voltage
250 V AC
Pollution degree
2