1078681 Phoenix Contact Control Relays

Product Details

• Height
  89 mm
• Nominal input voltage UN
  24 V DC
• Protective circuit
  Reverse polarity protection Polarity protection diode
• Type of switch contact
  Single contact
• Minimum switching voltage
  12 V (at 100 mA)
• Switching capacity min.
  1200 mW
• Ambient temperature (operation)
  -40 °C ... 70 °C
• Typical input current at UN
  18 mA
• Contact material
  AgSnO
• Maximum inrush current
  165 A (20 ms)
• Operating mode
  100% operating factor
• Connection method
  Screw connection
• Conductor cross-section solid (2 conductors with same cross section)
  0.5 mm² ... 2.5 mm²
• Conductor cross section AWG
  20 ... 10 (solid)
• Insulation
  Safe isolation, reinforced insulation
• Identification
  ISA-S71.04. G3 Harsh Group
• ECLASS 11.0
  27371601
• China RoHS
  Environmentally Friendly Use Period = 50 years
• Note
  The system installer must ensure the touch protection of the product (at voltages > 25 V AC/60 V DC). The product is a built-in device without protection against direct contact.
• Maximum altitude
  ≤ 2000 m
Typical response time
8 ms
Operating voltage display
Yellow LED
Maximum switching voltage
250 V AC/DC
Switching capacity
2 A (at 24 V, DC13)
Mechanical service life
3x 107 cycles
Stripping length
8 mm
Conductor cross section flexible
0.5 mm² ... 4 mm²
Rated surge voltage
6 kV
Overvoltage category
III
ECLASS 10.0.1
27371601
ECLASS 7.0
27371601
ETIM 7.0
EC001437
Type of note
Notes on operation
Depth
75 mm
Input voltage range in reference to UN
see diagram
Typical release time
10 ms
Contact type
1 N/O contact
Min. switching current
100 mA (at 12 V DC)
Limiting continuous current
6 A
Test voltage
4 kV AC (50 Hz, 1 min., winding/contact)
Connection name
Contact side
Conductor cross section solid
0.5 mm² ... 4 mm²
Torque
0.5 Nm ... 0.6 Nm
Standards/regulations
EN 50178
ECLASS 5.1
27371600
ECLASS 9.0
27371601
Utilization restriction
EMC: class A product, see manufacturer's declaration in the download area
Width
16 mm
Ambient temperature (storage/transport)
-40 °C ... 85 °C
Degree of protection
RT II (Relay)
Coil voltage
24 V DC
Power dissipation for nominal condition
0.43 W
Note regarding the switch contact
With tungsten leading contact
Interrupting rating (ohmic load) max.
264 W (at 24 V DC, observe contact derating)
Mounting position
any
Assembly instructions
In rows with zero spacing
Conductor cross section flexible (2 conductors with same cross section)
0.5 mm² ... 2.5 mm²
Designation
Corrosive gas test
Pollution degree
2
ECLASS 5.0
27371600
ECLASS 6.0
27371600
ETIM 6.0
EC001437